When zoning a factory, how are the boundary wall gate and the main factory door each checked?
For the boundary wall door, zone the whole plot; for the main door, zone the constructed area. The main door is the one through which you actually enter the house or factory building, not the boundary wall gate through which a vehicle enters, and both should fall on good pads, the main door above all.
Related questions
Can we also get the professions and diseases linked to each door pada?
Yes, every entrance has its related profession and the type of disease it can bring, and some padas are rog dwar (doors of disease). The teacher promised two charts, one for diseases and one for professions, since a complete door study takes seven to eight hours; residential and industrial doors are studied in detail in the industrial vastu module.
Can yellow mustard and gomti chakra be put at a South-West main boundary gate?
Yes, it will benefit. These two items are not limited to any direction and can be used anywhere. Put the yellow mustard in properly dug pits, because if it meets moisture and sprouts it does no good. The specific South-West gate remedy is taught separately.
Do the main door rules apply to the outer boundary gate too?
The boundary gate carries only about 10 percent weight. The door through which you enter the house itself is the main door; the outer one is just the boundary-wall gate.
Do these pada results apply to the boundary wall door, the main door or every door of the house?
There are three types of doors: the boundary wall door (for example the entrance of a multi-storey building or the gate of a bungalow), the main door through which you enter your own home, and room doors such as the kitchen or bedroom door. The interpretation applies mainly to the main door. The boundary wall door also plays a role, but much less, because even after entering the gate you cannot get into the house if the main door is locked.
If the main door and boundary gate face each other but fall on different pads, is it still good?
Yes, if the offset is within one pad (11.25 degrees). For example, a gate on N4 with a main door spread over N4 and N5, mostly in N4, or a main door on N4 with the gate on the N4-N5 junction, still counts as utsang (sammukh) dwar.
If the main door is on a negative pad, does a clockwise or anti-clockwise route to the boundary gate change its results?
Yes. A correctly placed door with an anti-clockwise (heen bahu) exit gives fewer good results than it should. A door on a negative pad such as E5 or E6, whose route runs clockwise to a gate on W4 or W5, gives much less negative effect than the pad alone would.